Discover How You Can Ensure Proper Installation of Your Air Conditioner

When you’re purchasing an air conditioner, you are likely to be under the untrue belief that level of efficiency is an essential factor that determines the cost of energy. However, this is not the case. The quality of air conditioning installation Brisbane has today matters to a greater extent. Poor installation of the air conditioner can lower its operating effectiveness by about 30%. According to research by Energy Star, about half of the HVAC installations are not correctly done, resulting in largely wasted energy dollars.  This condition can be prevented by choosing a competent contractor to install your new HVAC system properly.

Four primary things dictate the way a cooling system performs. The system has to be sized correctly, have sufficient airflow to operate, employ the right quantity of refrigerant and operate with ductwork that is tightly sealed. The good news is that you can enhance the performance of your air conditioner by addressing the below four parts during air conditioning installation Brisbane has to offer.

Sizing

Proper sizing of the air conditioner entails calculating the cooling load of a home, using a manual calculation from ACCA (Air Conditioning Contractors of America). After determining the load, the contractor selects the right size of A/C to perfectly meet your home’s cooling demands.  Poor sizing can lead to efficiency and comfort problems. For example, an air conditioner that is very large does not dehumidify the air properly due to frequent cycling. Also, frequent cycling decreases the system’s lifespan.

Ductwork

In case of a leaking ductwork, all the air from the A/C fails to reach your home living spaces, leading to a great loss of energy that leaks out from duct pipe connections that are poorly sealed. To avoid this kind of wastage, part of air conditioning installation in Brisbane should entail using duct tape that is metal-backed and mastic sealant to ensure the ductwork is airtight.

Airflow

The manufacturer of the A/C system should spell out the right airflow rates for contractors to use during Brisbane air conditioning installation and to adjust the amount of air circulating through the system. If the rate is too low, your home will not have enough cool air circulating. In addition, the system requires a specific quantity of air to flow through the evaporator coil. This facilitates heat absorption and transfer, thus allowing your home to cool.

Refrigerant

Similar to airflow adjustment, air conditioner installation expert should seek advice from the manufacturer specs on the most appropriate amount of refrigerant required to facilitate the transfer of heat in the condenser and the evaporator. If the system is not properly charged with refrigerant, it may result in higher energy costs and poor cooling capacity. See more at Alaska

You are likely to spend more when you employ a reputable AC contractor with education, training, and certification to do a quality installation.  However, it pays in future to find air conditioning installation Brisbane has to offer, especially if it’s done by competent contractors. It helps you avoid the negative effects that come with poor installation such as poor home comfort, early system failure, short A/C component lifespan, higher energy costs and higher initial gadget costs. You should ensure that the air conditioning installation Brisbane contractors offer meets the industry and manufacturer standards.

Leave a Reply

Your email address will not be published. Required fields are marked *